What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
16.06.2025 06:38

nine
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
These are simplified answers to the original question, and does not change anything I wrote above.
Do many women shave their vaginas?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
What does a fuse do?
One is “what exactly is in a ‘surge protector’ ? ”
A circuit breaker is similar, but is resettable.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Is Veuve Clicquot Brut a good champagne?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Here is a simplified AC power diagram.
For this case there are devices called Metal oxide varistors (MOV).
What is the best technique for inserting a tampon into one’s anus?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This is where this question deviates from being a 'generic' question, and becomes more specific.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
There are three different concepts here that are getting confused.
This is 'the assistant's answer'
Do you want to have an XXX chat?
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–16 [ OO OLAOYE OYEBODE ]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Why did my ex replace me so fast?
This is where the MOV conducts again, and dissipated the energy.
2024–10–10[John johnson John Johnson ]
The other is “what does a “fuse” do?”
How does the narcissist react when he realizes you no longer care?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This one hit behind the barn.
but I think this circuit , shows a few more pieces.
Why do men choose to marry a plain Jane woman over a pretty woman?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
A fuse is a non-resetable over current circuit protector.
How do you handle your mother-in-law after you heard her talking badly about you in the next room?
It also is a device that limits the change in current flow.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
What is truer than that which is true?
He then describes the function of a fuse.
but this device (an Inductor) … impedes the rapid changes in the current.
Upvotes:
How do I build rapport with anybody?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This device then solves the entire problem.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
At least they know the answer if they wanted it.
[old diagram got deleted by accident]
First Sentence:
These devices are installed between the “hot” and “neutral” and protective ground.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
The third is lightning and “how it gets conducted into a home.”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Barnstars:
At one ohm, the resistor has a maximum of 1 watt power.
One
what exactly is a ‘surge’ protector?
He then asserts :
the problem then depends on "how fast does the fuse operate?".
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
There are two important concepts here.
The bolt then partially travels down the line to your home.
It seems Mohan does not understand the difference between a comment and an Answer.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
In schematic diagrams this is the symbol for a fuse:
Now when you have a certain ac resistance, then a current flows in a loop.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What is lightning?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
He then describes Rainy Season and Lightning.
But it can get overloaded, and no longer works.
(Dc diagram shown, AC is similar).
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
eight
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
An AC voltage/ current source, and an ac inductive load.
a photo is worth a thousand words.
so, what happens?
The MOV will conduct when the voltage exceeds 50% of line voltage.
I post the exact comment here.
[image of Common-mode choke]
2024–10–14 [Omar Gharbi Omar Gharbi ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
But… the neutral is now “floating” because of the 1 ohm resistance.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Edit 2024–10.
So, the voltage could go up to 500 volts, and the fuse will not open up.